|
Multi-Channel Baluns
You can't just connect the wires - you'll lose signal
strength and picture quality. A video balun corrects this
problem by balancing impedance and other electrical
characteristics, which minimizes signal loss and noise.
It's important to use
video baluns when sending video over
Cat5
since the
impedance specifications of Cat5, Cat5e and Cat6 are 100
ohms. Video requires 75 ohm impedance and you'll introduce
artifacts to your video without a balun.
Multi-Channel Baluns
|
 4-Channel Video Balun
This passive video balun
connects up to four BNC coax cables to 8-conductor twisted
pair cables (RJ-45).
-
Compact size, can be screwed
down
-
Transmits color video
signals up to 400 meters (437.4 yards) or b/w video up
to 600 meters (656.2 yards)
-
Distances of up to 1
kilometer when used with
active baluns
-
Built-in noise filter
-
Cost saving: Eliminate long
runs of coaxial cable
-
Category 5 (Cat5) wire
recommended.
$51.47
|
|
 BNC
to COAX Video Balun with Serial Data Filter
This video balun has 4 channels, connects BNC to coaxial
cable, and has a filtered serial data line.
-
Four (4) channels for up to four (4) cameras
-
Compact size, can be screwed down
-
Transmits color video signals up to 400 meters (437.4
yards) or b/w video up to 600 meters (656.2 yards)
-
Distances of up to 1 kilometer when used with
active baluns
-
Built-in noise filter
-
Serial data filter
-
Cost saving: Eliminate long runs of coaxial cable
-
Category 5 (Cat5) wire recommended.
$55.88
|
|
4 Channel Active Video Receiver
 Your CCTV video over cat5 installation has never been easier
and more cost effective. Balun is the key component that
allows you to transmit VGA, RGB, YPbPr. YCbCr, S-Video and
Composite video or audio over Cat5.
It's important to use
video baluns when sending video over
Cat5 since the
impedance specifications of Cat5, Cat5e and Cat6 are 100
ohms. Video requires 75 ohm impedance and you'll introduce
artifacts to your video without a balun. Basically, if
there's an impedance mismatch the signal will be reflected
from the receiver back to the transmitter causing delays in
the signal transmission; the delays have a ghosting effect
on the picture.
• Transmit a full motion color or monochrome video signal
and data signal, Color range 1500 meters, B/W video signal
up to 2400 meters
• Five position distance range switch on Receiver
• System is integrated with alarm sensor or data
• Built-in transient protection and ground lifting,
damaging
voltage and spike problems are eliminated
• Power Supply Included
|
|
|
|
Video Output
|
1Vp-p, 75 Ohms |
|
DC Input |
DC 12V |
|
Power Consumption |
40mA (max) |
|
Video Gain Adjusting |
Up to 1500M |
|
Recommended Cable |
CAT-5 UTP Cable 4 pair |
$222.35
|
|
 8-Port Active Amplified
Hub
An
amplified, 8-port hub in a 1-inch tall rack mount style
case.
-
Adjustable power (DIP switches on front)
-
Full motion color or B/W video signal
-
Twisted pair terminal block
-
BNC out to monitors or multiplexers
-
Independent LED indicators
-
Power supply included.
$386.76
|
|
4-Channel
Passive Video Balun Receiver
|
Transceiver Type |
4CH Passive Video Balun
Receiver & Power Supply Hub (VPS) |
|
Video |
Frequency Response
Range: DC-5MHz; Common-Mode / Differential-Mode
rejection: 5KHz-5MHz 60dB type |
|
Wire Type |
24-16AWG UTP
Cat5
or
higher; DC loop resistance ≦18Ω/ 100m; Differential
capacitance: 62pF/m (max) |
|
Impedance |
UTP or Connection or
RJ-45: 100Ω; BNC Coax:75Ω |
|
Power Input |
n/a |
|
Power Transmission |
12V DC up to 750 ft Via
UTP Cat5e / 6 |
|
Dimensions |
7.9" x 6.7" x 1.8" |
|
Weight (lb) |
2.3 |
$95.59
|
|
8-Channel
Passive Video Balun Receiver
|
Transceiver Type |
8CH Passive Video Balun
Receiver & Power Supply Hub (VPS) |
|
Video |
Frequency Response
Range: DC-5MHz; Common-Mode / Differential-Mode
rejection: 15KHz-5MHz 60dB type |
|
Wire Type |
24-16AWG UTP
Cat5
or
higher; DC loop resistance ≦18Ω/ 100m; Differential
capacitance: 62pF/m (max) |
|
Impedance |
UTP or Connection or
RJ-45: 100Ω; BNC Coax:75Ω |
|
Power Input |
n/a |
|
Power Transmission |
12V DC up to 750 ft Via
UTP Cat5e / 6 |
|
Dimensions |
11.4" x 6.7" x 1.8" |
|
Weight (lb) |
4.3 lbs |
$154.41
|
|
16-Channel
Passive Video Balun Receiver
|
Transceiver Type |
16CH Passive Video Balun
Receiver & Power Supply Hub (VPS) |
|
Video |
Frequency Response
Range: DC-5MHz; Common-Mode / Differential-Mode
rejection: 15KHz-5MHz 60dB type |
|
Wire Type |
24-16AWG UTP
Cat5
or
higher; DC loop resistance ≦18Ω/ 100m; Differential
capacitance: 62pF/m (max) |
|
Impedance |
UTP or Connection or
RJ-45: 100Ω; BNC Coax:75Ω |
|
Power Input |
n/a |
|
Power Transmission |
12V DC up to 750 ft Via
UTP Cat5e / 6 |
|
Dimensions |
19.4" x 6.7" x 1.8" |
|
Weight (lb) |
7.1 lbs |
$213.24
|
|
8-Channel
Active Video Balun Receiver
|
Transceiver Type |
8CH Video Receiver
(Active) |
|
Video |
Frequency Response
Range: DC-6MHz; Common-Mode / Differential-Mode
rejection: 15KHz-6MHz 60dB type |
|
Wire Type |
24AWG UTP
Cat5
or
higher; DC loop resistance ≦18Ω/ 100m; Differential
capacitance: 62pF/m (max) |
|
Impedance |
UTP or Connection or
RJ-45: 100Ω; BNC Coax:75Ω |
|
Power |
AC100-240V 50/60Hz |
|
Transient Protection |
6KV 10 x 700 us
IEC61000-4-5 |
|
Dimensions |
17" x 3.3" x 1.7" |
|
Weight (lb) |
2.54 |
$135.00
|
|
16-Channel
Active Video Balun Receiver
|
Transceiver Type |
16CH Video Receiver
(Active) |
|
Video |
Frequency Response Range: DC-6MHz; Common-Mode /
Differential-Mode rejection: 15KHz-6MHz 60dB type |
|
Wire Type |
24AWG
UTP
Cat5
or higher; DC loop resistance ≦18Ω/ 100m;
Differential capacitance: 62pF/m (max) |
|
Impedance |
UTP or Connection or
RJ-45: 100Ω; BNC Coax:75Ω |
|
Power |
AC100-240V 50/60Hz |
|
Transient Protection |
6KV 10 x 700 us
IEC61000-4-5 |
|
Dimensions |
17" x
3.3" x 1.7" |
|
Weight (lb) |
2.9 |
$176.47
|
|
|
FREE Shipping on orders over $250.00!*